Skip to main content
Loading…
This section is included in your selections.

A. Installation permits for all backflow prevention assemblies shall be obtained from the Utility prior to installation. A separate permit shall be obtained for each required backflow prevention assembly to be installed, including replacement or relocation.

B. It shall be the duty of the person performing the work authorized by the permit to notify the Utility, orally or in writing, that the work is ready for inspection. No inspection shall occur sooner than twenty-four (24) hours from notification of the Utility. Any person requesting an inspection must have a good faith basis to believe that the work done will meet current Town codes and regulations.

C. Any work performed contrary to the provisions of the International Plumbing Code, Uniform Plumbing Code, or this code may be subject to a work stop order by the Utility or its authorized representative. Any persons engaged in or causing improper installation shall be informed in writing that work must cease until the Utility authorizes the continuation of the installation.

D. Whenever a permit is issued in error, on the basis of incorrect information supplied, or in violation of any ordinance, regulation or any provision of the International Plumbing Code or this code, the permit may be revoked or suspended by the Utility upon written notice. ((O)07-21, 03/21/2007)